Mad Drop Blackshine Ceramic Tire Dressing With SiO2

1. Clean the surface. Thoroughly remove dirt, dust, grease and residues of previously applied care products from the tyre sidewall or plastic surface.
2. Before application, make sure the surface is completely clean and dry.
3. Apply a small amount of Mad Drop Blackshine to a clean applicator.
4. Spread the product evenly across the surface, working in small sections.
5. Use the product sparingly. Avoid applying excessive amounts – a thin and even layer makes it easier to control the final result.
6. If excess product, build-up or uneven areas remain, level them out using a clean applicator or microfiber cloth.
7. Make sure the product has been evenly distributed over the entire surface and that no excess product remains.
8. Mad Drop Blackshine is ready to use – no dilution is required.

For best results, apply the product to a clean, cool and properly prepared surface. Remove dirt, grease, dust and residues of previous care products, especially from tyre sidewalls.

Do not apply in direct sunlight or on hot surfaces. Test on an inconspicuous area before use on sensitive or unfamiliar plastics.

Final results may vary depending on the type, age and condition of the surface and the quality of preparation.

Keep out of reach of children. Avoid contact with eyes. If the product gets into the eyes, rinse carefully with water. If irritation persists, seek medical attention.

Wash hands after use. Use in a well-ventilated area. Do not use on hot surfaces.

Do not apply to the tyre tread. Do not use on pedals, floor mats, brake system components or any other surfaces where increased slipperiness could affect grip or safety.

Do not use the product for purposes other than its intended use. Before use, read the information provided on the product label and follow all safe-use instructions stated on the label.